On : My Thoughts Explained
Here is a Guide for Car Decal Installation from Start to Finish
Personalizing and sprucing up your car is something that is very much possible with all the options at your disposal. Car customization, for instance, can be done with the popular and easier option of using a custom decal. You will need to put in some effort to learn how to add some custom decal but you can bet it isnt rocket science, and the results will be amazing. Here is a step by step guide to help you add your own decals and you can always check it out here to have a look at the wide variety of car decals available.
Identifying the exact location that you would want to place your car decal is the very first step to help you with a successful installation. The best location is a flat surface whose texture can hold the dcor together. Your dashboard, window or body panel will do just ensure the custom decal you choose can withstand the specific elements of the spot. The next step is known as dry fitting, placing it on the selected location to ensure it fits perfectly. Keep in mind dry fitting is simply placing the decal on the spot you have identified without necessarily peeing off the back paper.
As you dry fit, you might want to pay enough attention to the exact spot of the decal, so you have it centered and straight. This is where you need a small level or a measuring tape so you can measure its exact position nearest to the edges to ensure it is straight. Armed with accurate measurements, you can then have the exact location of your dry fitted decal marked out using a tape measure to ensure the coordinates are accurate.
The next step here when it comes to DIY decal installation is to have the place prepped so that your decal can fit in perfectly. You will need a fast drying cleaning solution such as rubbing alcohol and a clean, lint-free towel. You can then peel off the backing on the decal which you can do in two ways. This you can do by peeling off the entire backing paper all at once or doing it gradually as you lay on the clean surface. Should you use the partial method, ensure you are applying some bit of pressure to your decal, so you dont end up bunching the decal. As you press down the decal applying firm pressure, you might want to ensure there are no bubbles so that the decal sets properly. Allow to sit for 30 minutes and your beautiful car dcor will be good to go.