Configuring a Fast Internet Router
We cannot imagine life without fast internet. A business would suffer great losses if its internet connections were slow. You thus need to invest n a much faster router. You then need a way to set it up. You shall need some steps to follow in doing this.
You need to place the router at a place where all your devices see it. Make sure it is not sitting in a Wi-Fi dead spot. If the optimum position is far, you can get a cable that shall make the connection to the gateway Ethernet port. Alternatively, you can opt for the more elegant mesh-style router. This usually comprises a node at the gateway, then others spread out in the house. This way, all corners are covered by the network. You can be informed more at the Router Login Netgear website. Place the router on a flat surface as you are setting it up.
You then need to configure a gateway. Some routers will come with a WAN port for connecting to a gateway preconfigured. For others, they shall pick form those available and assign them as WAN or LAN. You shall begin by disabling the current router. Do so even for one in the modem. This is how you stop two routers from competing. Having both make a meshwork scenario impossible. Using the gateway’s IP address, go to a browser and find its configuration page. Go to the allocation mode tab and click on passthrough option. You should call your ISP the minute you cannot see this. You may be blocked from it. You need to then turn off the modem’s Wi-Fi access point. It will be pointless to leave it on. You then need to reboot the gateway.
Fix the gateway to the new router. As it is off, connect using an Ethernet cable on its LAN port to the router’s WAN port. Then connect your PC to the router and the phone line to the modem. Switch on the gateway. This might take time for any response to be seen, so be patient. Do the same for the router.
You should then change the admin password on the wireless router. There might be a smartphone app that shall make it easier for you. If not, use the browser-based option. You should key in the router’s IP address and you will get the necessary results. Use the provided admin username and password on the package. Follow this by a changing the password. Keep the password safe.
Let the firmware update run. It could be out of date. The device should attempt an automatic update cycle. Once it is done, you need to reboot it. You should then set up a Wi-Fi network password. You can do this in the connectivity tab. You should rely on the WAP2 encryption, seeing as the WEP option is not adequate for this.